This is a drop-in speaker solution for Rapido SW switchers that use the dual-11x15 factory speaker. If you have a very early-run SW using the iPhone 5 speaker, this solution will not work and I will not have a speaker for these models.
 
You will likely need to remove the two PCB screws between the decoder and speaker. A strap of tape over the top of the speaker and PCB secures everything. Please see the second photo for installation instructions. The long hood WILL easily accommodate this solution with just a touch of wiggle room left. If yours does not fit, you've either used tapes or wires that are too thick or you're not properly re-installing the long hood.
 
The long-hood needs to seat down strait, then tilt the cab back a bit to snug the hood clips in, finally poking the long-hood front tab into the chassis. If you angle the long-hood nose down first and rock back to seat the rear, it will not fit and you may bend or break the front headlight LED assembly. This is the case even with the stock speaker. To reiterate, the long-hood can be a little tricky to seat back down. It's not the speaker's fault.
 
The speaker comes fully assembled and tested.
 
Dimensions: 6mmH x 15mmW x 32mmL
 
VIDEO: https://youtu.be/XX41C7rvIBM